Page 1 of 1

Here's a fun part for RC fan ducts.

Posted: Thu Feb 08, 2018 2:58 pm
by RotaryKing
Here's a fun part that can be made with your Proto-MAX machine!

This is just a fun part I was playing with. I like this type of shape for my RC ducted fans.
Light weight plastic is best for flying things, but my Proto-MAX can even make this in Steele or Titanium.

Enjoy!

Re: Here's a fun part for RC fan ducts.

Posted: Thu Feb 08, 2018 3:16 pm
by Carl O
Nice! Here is what it looks like when rendered. Do you happen have a picture of the final part to share?

Carl.
RC_Fan_Duct.jpg

Re: Here's a fun part for RC fan ducts.

Posted: Fri Feb 09, 2018 7:59 am
by RotaryKing
Here's the finished part, after going over it with the polishing wheel.

The part shown was cut in 1/4 inch thick Aircraft Aluminum, and it took about 23 minutes to cut.