What is the smallest diameter the jet stream can cut?

General abrasive waterjet discussions.
Post Reply
User avatar
Jessica V
OMAX Employee
Posts: 1
Joined: Wed Sep 20, 2017 9:03 am

Tue Nov 07, 2017 9:29 am

What is the smallest diameter the jet stream can cut? How small of a radius?

User avatar
Carl O
OMAX Employee
Posts: 24
Joined: Thu Sep 14, 2017 10:43 am
Location: OMAX Corporation

Wed Nov 08, 2017 12:44 pm

The Quick Answer:

The nozzle produces a cut of about 0.030" (0.75 mm) in diameter, or about 0.15" (0.38 mm) radius.

Additional Discussion:

The diameter of the "mixing tube" portion of the ProtoMAX nozzle is about 0.030" (approximately 0.75 mm). This means that the narrowest slot one can cut is about this amount, and the sharpest inside corner radius would be about 1/2 this amount, or about 0.015" (0.38 mm).

With a brand new mixing tube, the actual diameter of the cut may be very slightly smaller, perhaps 0.028" (0.71 mm) due to various factors such as tolerances and jet behaviors within the nozzle.

As the nozzle wears, it will expand in diameter slightly over time, growing larger than the 0.030" design specification. The advanced user can easily adjust the "tool offset" in the software to compensate for this, should one desire to maintain maximum precision.

Tip: The diameter of the cut is often referred to as the "kerf width" or "kerf" of the jet.

Post Reply