ProtoCLOCK 11 in. clock Part 1

Made something amazing? Show everyone here.
Post Reply
sailboat
Posts: 6
Joined: Wed Jun 19, 2019 2:45 pm

Fri Jun 28, 2019 6:44 am

image001.jpg
Clock face design – Robert W.
Clock face designed modified and cut – Christine L.
Clock encasement design and cut – Ian M.
Assembly – Patty B.

This project was an accidental team effort. Robert designed the clock face and Christine drew it in LAYOUT and cut 3 pieces.
Robert gave one of the pieces to Patty. Patty saw a display in the OMAX demo room as an idea for the clock embellishment.
image001.jpg
Patty needed to cut out the back hole in the mirror for the clock motor, and Ian needed to test cutting brittle materials on the ProtoMAX. Ian looked at the plans and created and cut the housing design of the clock.

Materials and cost:
Omax ProtoMAX part $ cost Vendor
Clock face 35 steel supply store
dials and motor 8 Amazon.com
lights 5 ebay
mirror 4.5 Michael's
spacers x 5 68 steel supply store
glaze 6 Home Dept
1 x 12 x 12 in. HDPE plastic 15 online store
Screws and nuts x 4 3 hardware store
144.5

Click download the files below for the ProtoClock.
Attachments
Clock_Spacer.omx
(9.93 KiB) Downloaded 19 times
Clock_Spacer.dxf
(8.2 KiB) Downloaded 17 times
image003.jpg
Post Reply